If you’re installing a luxury vinyl plank for the first time, chances are higher that inevitable mistakes will occur.
The result can be dreadful if the planks are not installed appropriately. Moving forward, it will cost you your precious time and money.
We want you to be vigilant from the first step. Hence, we will discuss the top 5 common mistakes you must avoid.
1. Cutting the Sheet Improperly
Sheet vinyl comes in rolls. It should be measured and cut in an organized way. If you cut and fit the same without folding and leaving the gaps in the corner, it will impact the look and feel of the floor. To eliminate this, you must measure the room before ordering the sheets.
2. Not Removing the Baseboards
You won’t get a properly finished edge if you don’t remove the baseboards. It can lead to slight gaps around the edges. You can lay the planks against the walls, allowing the baseboards to go over the edges. Otherwise, measure and cut away a small amount of sheet to allow the same fit neatly.
Also, ensure you aren’t pressing the baseboards tightly against the flooring, as it can cause buckling to the plank end.
3. No Planning of the Layout
Most people skip the initial planning of the floor layout before they engross themselves in the process of installing luxury vinyl plank flooring. Hence, it leads to a waste of time and money. You should figure it out in advance to avoid any untoward situation. It will help you determine whether your floor will end on a partial or full width. For better results, you can split the difference on both ends.
4. Using Too Much Adhesive
You need the recommended amount of adhesive, as putting in a greater quantity of it will result in seeping through the sheet gaps. Also, the uneven application may lead to ridges. Double-check the manual before starting the installation procedure.
5. Applying the Material on an Unprepared Surface
If you’re dealing with a wooden subfloor or a concrete floor, you must check whether it’s prepared for vinyl. Installing over an inadequate base may lead to scenarios like repair or replacement.
Clean the surface properly. Ensure that no debris is left on the surface and it’s dry before you start the installation. However, if the floor is damp, choose a material that fits the situation well.
We Got you Covered
Avoiding these mistakes will help you to have a mesmerizing and long-lasting vinyl floor. It needs dedication and time to finish the task efficiently. We understand that you have to run the daily errands, which leaves less time to focus on this. At Fritzel Flooring, our experts are ready to make this a cakewalk for you. If you’re from Fort Collins and need flooring experts, you can hire professionals from our company. Rest assured, your project will be in good hands!
